Static Dhcp Screen - ZyXEL Communications NBG-418N v2 User Manual

Fig ure 71 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 44 Network > DHCP Server > General
L ABEL
DHCP Mode
IP Pool Range
Max Lease Time
DNS Sever1
DNS Sever2
Apply
Reset
9.5 Sta tic DHC P Sc re e n
This screen allows you to assign IP addresses on the LAN to specific individual computers based on their
MAC addresses. You can also use this screen to configure the DNS server information that the NBG-418N
v2 sends to the DHCP clients.
To change your NBG-418N v2's static DHCP settings, click
following screen displays.
Chapter 9 DHCP Server
DESC RIPT IO N
Select DHC P se rve r from the drop-down list to have the NBG-418N v2 act as a DHCP
No ne
server. Otherwise, select
and RFC 2132) allows individual clients (computers) to obtain TCP/IP configuration at
startup from a server. Choose
otherwise. Choose No ne to disable the NBG-418N v2 acting as a DHCP server. When
configured as a server, the NBG-418N v2 provides TCP/IP configuration for the clients. If
not, DHCP service is disabled and you must have another DHCP server on your LAN, or
else the computers must be manually configured. When set as a server, fill in the following
four fields.
This field specifies the range of the contiguous addresses in the IP address pool for LAN.
This field specifies the Maximum time interval the device can be idle before the IP address
on the LAN link is disconnected. Default is 120 minutes, maximum is 525600 minutes
Type the First DNS server IP address of the DHCP server.
Type the Second DNS server IP address of the DHCP server.
Click Apply to save your changes back to the NBG-418N v2.
Re se t
Click to begin configuring this screen afresh.
NBG-418N v2 User's Guide
100
. DHCP (Dynamic Host Configuration Protocol, RFC 2131
DHC P Se rve r option unless your ISP instructs you to do
Ne two rk > DHC P Se rve r > Sta tic DHC P . The