ZyXEL Communications NBG-418N v2 User Manual page 147

Table 65 Maintenance > Sys Op Mode > General (continued)
L ABEL DESC RIPT IO N
Universal Repeater Use
network and you want the NBG-418N v2 to wirelessly relay communications from its wireless
clients to it.
Client Bridge Use
access point.
Apply Click
Reset Click
If you select Ro ute r mode, the following pop-up message window appears.
Fig ure 114
Maintenance > Sys Op Mode > General: Router
• In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN Ethernet ports have
different IP addresses.
• The DHCP server on your device is enabled and allocates IP addresses to other devices on your local
network.
• The LAN IP address of the NBG-418N v2 is set to 192.168.1.1.
• You can configure the IP address settings on your WAN port. Contact your ISP or system administrator
for more information on appropriate settings.
If you select a non-router mode (
message window appears.
Fig ure 115 Maintenance > Sys Op Mode > General: Non-Router
• In non-router mode, all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN. There is no
WAN port.
• The DHCP server on your device is disabled. In this mode there must be a device with a DHCP server
on your network such as a router which can allocate IP addresses or else you need to manually assign
IP addresses to devices on your network.
• The LAN IP address of the NBG-418N v2 is set to 192.168.1.2.
Unive rsa l Re pe a te r mode if there is an existing wireless router or access point in your
C lie nt Bridg e mode if your device needs a wireless client to connect to an existing
Apply to save your settings.
Re se t
to return to the previous screen settings.
Ac c e ss Po int , Unive rsa l Re pe a te r
NBG-418N v2 User's Guide
147
or C lie nt Bridg e ) the following pop-up