ZyXEL Communications NBG-418N v2 User Manual page 90

Table 39 Network > WAN > IPv6 (continued)(PPPoE)
L ABEL DESC RIPT IO N
Connection Type Select
Select
the router automatically disconnects from the PPPoE server. If you select this you will need to
enter the number of minutes in the Idle timeout field.
Select
Connect/ Click
Disconnect the connection.
IPv6 DNS Settings
Obtain DNS Server Click the
address from your ISP's server.
automatically
Use the following Click
DNS address
Primary/Secondary Enter the first/second IPv6 DNS server address assigned by the ISP.
DNS Address
Lan IPv6 Address Settings
Enable DHCP-PD Click
DHCP clients.
LAN IPv6 Address Enter the IPv6 address for the LAN interface in this field.
LAN IPv6 Link-Local This shows the IPv6 Link-local address in the LAN side. This is used by NBG-418N v2 when
Address communicating with neighboring devices on the same link. It allows IPv6-capable devices
to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable Click
Autoconfiguration network address that are not managed by a DHCPv6 server.
Autoconfiguration Select
Type local address via stateless autoconfiguration.
Select
IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router If you select
Advertisement amount of time in minutes that a device may have an IPv6 address before it is required to
Lifetime renew the lease.
IPv6 Address If you select
Range(Start) server assigns to the clients. Enter the smallest value of the last block of the IPv6 addresses
which are to be allocated.
IPv6 Address If you select
Range(End) server assigns to the clients. Enter the largest value of the last block of the IPv6 addresses
which are to be allocated.
IPv6 Address If you select
Lifetime valid.
Apply Click
Reset Click
Chapter 7 WAN
C o ntinuo us if you do not want the connection to time out.
C o nne c tio n o n De m a nd if you want to connect for a certain amount of time before
Ma nua l if want to make the connection manually.
C o nne c t to establish PPPoE connection to the IPv6 Internet or click
O b ta in DNS se rve r a ddre ss a uto m a tic a lly
Use the fo llo wing DNS a ddre ss
Ena b le DHC P- PD (DHCP-Prefix delegation) to allow NBG-418N v2 assign prefixes to
Ena b le Auto c o nfig ura tio n
if you want the devices on your local area network to obtain
SL AAC + Sta te le ss DHC Pv6
Sta te ful(DHC Pv6) when the devices connected to your LAN needs to have their TCP/
SL AAC + Sta te le ss DHC Pv6
Sta te ful (DHC Pv6) , specify the range of IPv6 addresses from which the DHCPv6
Sta te ful (DHC Pv6) , specify the range of IPv6 addresses from which the DHCPv6
Sta te ful (DHC Pv6)
, specify how long (in minutes) the IPv6 addresses remain
Apply
to save your changes back to the NBG-418N v2.
Re se t
to begin configuring this screen afresh.
NBG-418N v2 User's Guide
90
radio button to get a DNS server address
radio button to use a fixed DNS address.
if you want the interface to automatically generate a link-
, type in the Ro ute r Adve rtise m e nt L ife tim e
Disc o nne c t to stop
which is