Subchart A-1: Simple Motor Setup Using V/F Control, Or Serial Operation; Of Multiple Motors - YASKAWA FSDrive-MV1000 Instructions Manual

◆ Subchart A-1: Simple Motor Setup Using V/f Control, or Serial Operation of Multiple
Motors
Subchart A-1 describes the setup procedure when using V/f Control. The flowchart below describes simple motor setup
for V/f Control without PG feedback. V/f Control is suited to applications like fans and pumps.
Figure 4.9
<1> When running multiple motors, Auto-Tuning is not possible.
Figure 4.9 Simple Motor Setup Using V/f Control, or Serial Operation of Multiple Motors
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions
From
Flowchart
A
Enter the number of motor poles for E2-04.
Turn on the main circuit power.
Is
the motor
cable longer than 50
meters?
<1>
NO
Run the motor without load; check the rotation direction and operation.
Verify external signal commands to the drive work as desired.
Couple the load or machine to the motor.
Run the machine and check for desired operation.
Return to
Flowchart
A
YES
Perform Stationary Auto-Tuning for
Line-to-Line Resistance (T1-01 = 2).
4.4 Start-Up Flowcharts
4
91