Siemens SCALANCE WLC711 Maintenance Manual page 48

2 In the System Log Level section:
•
From the Wireless Controller Log Level drop-down list, select the least severe log level for the
controller that you want to receive: Information, Minor, Major, Critical.
For example, if you select Minor, you receive all Minor, Major and Critical messages. If you select
Major you receive all Major and Critical messages. The default is Minor.
•
From the Wireless AP Log Level drop-down list, select the least severe log level for the AP that
you want to receive: Information, Minor, Major, Critical.
For example, if you select Major you receive all Major and Critical messages. The default is Major.
•
Click Report station events on controller to collect and display station session events on the
controller station events log.
•
Click Forward station session events as traps to forward station events as SNMP traps.
3 Click Apply.
Enabling and Defining Parameters for Syslog
To Enable and Define Parameters for Syslog:
1 From the top menu, click Wireless Controller.
The Wireless Controller Configuration screen is displayed.
2 From the left pane, click Logs.
The Logs Configuration screen is displayed.
3 In the Syslog section, to enable the Syslog function for up to three syslog servers, select the
appropriate checkboxes.
4 For each enabled syslog server, in the IP box, type a valid IP address for the server on the network.
In the Port # box, the default port for syslog (514) is displayed.
5 To include all system messages, select the Include all service messages checkbox. If the box is not
selected, only component messages (logs and traces) are relayed. This setting applies to all three
servers. The additional service message is: DHCP messages reporting users receiving IP addresses.
6 To include audit messages, select the Include audit messages checkbox.
7 To include station session event messages, select the Include station event messages checkbox.
8 In the Application Logs drop-down list, click the log level (local.0 - local.6) to be sent to the syslog
server. This setting applies to all three servers.
9 If the Include all service messages checkbox is selected, the Service Logs drop-down list becomes
available. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies to
all three servers.
10 If you select the Include audit messages checkbox, the Audit Logs drop-down list becomes
available. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies to
all three servers.
11 If you select the Include station event messages checkbox, the Station Logs drop-down list
becomes available. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting
applies to all three servers.
12 To apply your changes, click Apply.
SCALANCE WLC711 Maintenance Guide
Performing System Maintenance
Enabling and Defining Parameters for Syslog
48