The Static Route Screen - ZyXEL Communications LTE7460-M608 User Manual

6.4 The Static Route Screen

Use this screen to view and configure IP static routes on the LTE7460-M608. Click Home Network > Static
Route to open the following screen.
Figure 25 Home Network > Static Route
The following table describes the labels in this screen.
Table 14 Home Network > Static Route
LABEL
Static Route
Enable Static Route
Apply
Reset
Static Route List
Add New
#
Destination IP
Subnet Mask
Interface
Gateway
Metric
Action
Reset
Chapter 6 Home Network
DESCRIPTION
Select the check box to enable the static route on the LTE7460-M608.
Click Apply to save your changes back to the LTE7460-M608.
Click Reset to reload the previous configuration for this screen.
Click Add New to set up a new static route on the LTE7460-M608.
This field displays the index number of an individual static route.
This field specifies the IP network address of the final destination. Routing is always
based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the WAN interface through which the traffic is routed.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
This is the "cost" of transmission for routing purposes.
Click Edit to go to the screen where you can set up a static route on the LTE7460-
M608.
Click Delete to remove a static route from the LTE7460-M608.
Click Reset to reload the previous configuration for this screen.
LTE7460-M608 User's Guide
44