Firewall > Dmz Screen - ZyXEL Communications LTE7460-M608 User Manual

The following table describes the labels in this screen.
Table 23 Networking > Firewall > ALG
LABEL
Application Layer Gateway (ALG) Settings
FTP ALG
TFTP ALG
PPTP ALG
RTSP ALG
SIP ALG
Apply
Reset
7.10 Firewall > DMZ Screen
Click Networking > Firewall > DMZ to open the DMZ screen. Use this screen to specify the IP address of a
default server to receive packets from ports.
Figure 55 Networking > Firewall > DMZ
The following table describes the labels in this screen.
Table 24 Networking > Firewall > DMZ
LABEL
Enable DMZ
IP Address
Apply
Reset
Chapter 7 Networking
DESCRIPTION
Select Enable for File Transfer Protocol (FTP) ALG to detect FTP traffic and help build
FTP sessions through the LTE7460-M608, otherwise select Disable.
Select Enable for Trivial File Transfer Protocol (TFTP) ALG to detect TFTP packets and
help build TFTP sessions through the LTE7460-M608, otherwise select Disable.
Select Enable for Point-to-Point Tunneling Protocol (PPTP) ALG to detect PPTP and
help build PPTP sessions through the LTE7460-M608, otherwise select Disable.
Select Enable for Real Time Streaming Protocol (RTSP) ALG to detect RTSP traffic and
help build RTSP sessions through the LTE7460-M608, otherwise select Disable.
Select Enable for Session Initiation Protocol (SIP) ALG to detect SIP traffic and help
build SIP sessions through the LTE7460-M608, otherwise select Disable.
Click Apply to save your changes back to the LTE7460-M608.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Click on the check box to enable the DMZ in your LTE7460-M608.
Enter the IP address of the default server which receives packets from ports.
Click Apply to save your changes back to the LTE7460-M608.
Click Reset to reload the previous configuration for this screen.
LTE7460-M608 User's Guide
70