Configuring Static Route For Routing To Another Network - ZyXEL Communications LTE7460-M608 User Manual

3.4 Configuring Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to the
LTE7460-M608's LAN. The router may be used to separate two area networks. This tutorial shows how to
configure a static routing rule for two network routings.
In the following figure, router R is connected to the LTE7460-M608's LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1 network) to
computer B (in N2 network), the traffic is sent to the LTE7460-M608's WAN default gateway by default. In
this case, B will never receive the traffic.
You need to specify a static routing rule on the LTE7460-M608 to specify R as the router in charge of
forwarding traffic to N2. In this case, the LTE7460-M608 routes traffic from A to R and then R routes the
traffic to B.
Chapter 3 Tutorials
LTE7460-M608 User's Guide
19