Agilent Technologies N9310A User Manual page 85

Sweep Trigger
Point Trigger
N9310A User's Guide
Pressing this softkey reveals a submenu of choices for
triggering a full sweep. Use this softkey to select triggering
immediately, triggering by the
either the positive or negative edge of a signal supplied to
the TRIGGER IN connector.
• Default value: Immediate
• Key sequence:
Pressing this softkey reveals a submenu of choices for
triggering a sweep point- by- point. Use this softkey to select
the way triggering the next sweep point after the dwell time
of the previous point as triggering immediately and
automatically, or triggering by pressing the
triggering on either the positive or negative edge of a
external signal supplied to the TRIGGER IN connector.
• Default value: Immediate
• Key sequence:
Immediate This softkey is one of the choices in both the Sweep Trigger
and the Point Trigger submenu. If you set both the Sweep
Trigger and the Point Trigger to Immediate, the signal generator
initiates a sweep over all the points as soon as you select a
sweep mode (RF/LF/Ampl).
• Key sequence:
Trigger key This softkey is one of the choices in both the Sweep Trigger
and the Point Trigger submenu. If you set both the Sweep
Trigger and the Point Trigger to key, the signal generator arms a
sweep as you select a sweep mode and requires you to press
the
Trigger
• Key sequence:
> Sweep Trigger
Sweep
> Point Trigger
Sweep
> Sweep Trigger > Immediate
Sweep
> Point Trigger > Immediate
Sweep
hardkey to initiate a sweep point by point.
> Sweep Trigger > Trigger Key
Sweep
> Point Trigger > Trigger Key
Sweep
Key Reference
hardkey, or triggering on
Trigger
hardkey, or
Trigger
4
79