Agilent Technologies N9310A User Manual page 120

6 Subsystem Command Reference
Amplitude Sweep State
114
:SWEep:AMPLitude:STATe ON|OFF|1|0
:SWEep:AMPLitude:STATe?
This command initiates your signal generator to sweep in a
different manner, according to the sweep trigger or point
trigger settings:
•
If the sweep trigger and point trigger are set to
IMMediate , sending the command
":SWEep:AMPLitude:STATe ON"
initiates an amplitude sweep immediately:
•
If either the sweep trigger or point trigger is set to
sending the command
ON" arms an amplitude sweep.
Sending command
initiates the amplitude sweep.
•
If either the sweep trigger or point trigger is set to EXT,
sending the commands
amplitude
ON"
arms an
needed to initiate the
external signal should be input into the signal generator.
The query returns the current amplitude sweep state.
Range
*RST value
Returned data
Front panel access
":SWEep:AMPLitude:STATe
":TRIGger IMMediate"
":SWEep:AMPLitude:STATe
sweep. No further command is
amplitude
sweep, but a proper
On (1), OFF (0)
OFF
1, 0
Sweep > Sweep Mode > Amplitude
Sweep > Sweep Mode > Off
KEY,
N9310A User's Guide