Agilent Technologies N9310A User Manual page 83

N9310A User's Guide
Step Sweep
Pressing this softkey reveals a submenu of softkeys to
configure the parameters of a step sweep, including:
•
•
•
• Key sequence:
RF Start
Pressing this softkey allows you to set the start frequency in
an RF sweep. The allowed frequency range is 9 kHz to 3
GHz, with 0.1 Hz minimum increment. The start frequency
should always be set less than the stop frequency in an RF
sweep.
• Default value: 9.0000 kHz
• Key sequence:
RF Stop
Pressing this softkey allows you to set the stop frequency in
an RF sweep. The allowed frequency range is 9 kHz to 3
GHz, with 0.1 Hz minimum increment. The stop frequency
should always be set greater than the start frequency.
• Default value: 3.000 000 0000 GHz
• Key sequence:
LF Start
Pressing this softkey allows you to set the start frequency in
an LF sweep. The allowed frequency range is 20 Hz to 80
kHz, with 0.1 Hz minimum increment. The start frequency
should always be set less than the stop frequency in an LF
swept.
• Default value: 20.0 Hz
• Key sequence:
RF/LF start and stop frequencies
Amplitude start and stop power levels
Number of point s in a sweep and the dwell time at
each point.
> Step Sweep
Sweep
> Step Sweep > RF Start
Sweep
> Step Sweep > RF Stop
Sweep
> Step Sweep > LF Start
Sweep
Key Reference 4
77