Agilent Technologies N9310A User Manual page 127

External Point Trigger Slope
Sweep Direction
N9310A User's Guide
:SWEep:PTRG:SLOPe EXTN|EXTP
:SWEep:PTRG:SLOPe?
This command toggles the slope of external trigger source
between negative (
is valid only when an external trigger source is properly
connected and enabled.
If you have selected EXT (an external trigger source), the
query returns the current slope of the external trigger
source. If you have NOT selected EXT or you preset the
signal generator, the query returns "NA".
Range
*RST value
Returned data
Front panel access
:SWEep:DIRection UP|DOWN
:SWEep:DIRection?
This command sets the sweep direction of an RF, LF or an
amplitude sweep to either of the following choices:
• UP - sweeps from start point to stop point
• Down - sweeps from stop point to start point
The query returns the current sweep direction.
Range
*RST value
Returned data
Front panel access
Subsystem Command Reference
EXTN ) and positive (
EXTN, EXTP
NA
EXTN, EXTP, NA
Sweep > Point Trigger > Trigger In Neg/Pos
UP, DOWN
UP
UP, DOWN
Sweep > Sweep Direction
EXTP ). This command
6
121