Agilent Technologies N9310A User Manual page 125

Sweep Repeat
Sweep Trigger
N9310A User's Guide
:SWEep:REPeat SINGle|CONTinuous
:SWEep:REPeat?
This command toggles the sweep repeat between single and
continuous.
The query returns the current sweep repeat state.
Range
*RST value
Returned data
Front panel access
:SWEep:STRG IMMediate|KEY|EXT
:SWEep:STRG?
This command sets the sweep trigger mode to one of the
following choices:
• IMMediate
- Selecting this mode immediately triggers
signal generator to sweep from the first point to the final
point in a sweep sequence automatically.
• KEY
- Selecting this mode arms a sweep. The armed
sweep will be initiated by sending the
"TRIGger:IMMediate" command.
• EXT
- Selecting this mode enables an external trigger
source to initiate an armed sweep.
The query returns the current sweep trigger mode.
Range
*RST value
Returned data
Front panel access
Subsystem Command Reference
SINGle/CONTinuous
CONTinuous
SING, CONT
Sweep > Sweep Repeat
IMMediate, KEY, EXT
IMMediate
IMM, KEY, EXT
Sweep > Sweep Trigger
6
119