Agilent Technologies N9310A User Manual page 11

N9310A User's Guide
FM
• configures a frequency modulation.
FM
• configures a phase modulation.
Pulse
• configures a pulse modulation.
I/Q
• actives an I/Q modulation.
Sweep
• configures RF/LF/Amplitude sweep.
Trigger
• triggers an armed sweep.
Utility
• sets the system configurations
Local
• returns the signal generator from remote to local.
File
• saves, recalls or deletes customized configuration files.
LF Out
• configures a low frequency signal.
7 Mod On/Off
Pressing
state between On and Off. A MOD On/Off annunciator is
visible on the screen, indicating whether the modulator is
enabled or not.
You also have to activate each individual modulation (for
example,
AM
to the output carrier signal, even though the modulator is
enabled (MOD On).
8 Knob
The knob increases or decreases a value or a numeric
digit, or moves to select an item up and down in a list.
9 Arrow keys
The left and right arrow keys shift the selected
digit in the active entry area of the display; Once an
individual digit is selected, you can change its value by
rotating the knob.
10 RF On/Off
The
between On and Off. A RF On/Off annunciator is always
visible on the display, indicating whether the RF output is
enabled or not.
11 RF Out connector
output for RF signals. The impedance is 50 ohm. The damage
level is +36 dBm maximum.
Mod
hardkey toggles the modulator
On/Off
> AM On), otherwise no modulation is applied
RF
hardkey toggles the RF output state
On/Off
This female N- type connector provides the
Overview 1
5