System Configuration - TANDBERG 6000 User Manual

Videoconferencing system
Table of Contents

Advertisement

System configuration

• Switch the system on by activating the power switch on the codec (located on the right hand side at the rear of
the codec). A green light is shown (located in the center on the front of the codec).
• After the system has performed a self-test routine, product logo and a 'Welcome' menu will be displayed on the
monitor.
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key 'System Info' (on
the remote control) to view line status.
menu
P
M
RESS
ENU ON THE REMOTE CONTROL
'L
S
'
INE
ETUP
MENU AND SET
• Enter System Name to identify the system during an MCU conference. Select 'Utilities', 'System Name' and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in 'Terminal Settings', 'Language'.
• If you are using two monitors, set 'Utilities', 'Dual Monitor: On'.
• To activate AES Encryption, MultiSite and/or Presenter, enter an option key (see paperwork accompanying your
system), see
'Terminal Settings', 'Software Options'.
• Press C
on the remote control. A dial tone should be heard if the network is active.
ONNECT
connect
• Using the monitor remote control, adjust the volume on the monitor to a level of your choice. This
volume will be the default volume for all calls.
TANDBERG Videoconferencing System
. S
'T
ELECT THE MENU
'E
: O
'.
NABLED
FF
S
', 'N
', 'ISDN-BRI
ERMINAL
ETTINGS
ETWORK
17
Installation
NOTE
T
HESE SETTINGS ARE ESSENTIAL
FOR OPTIMAL SYSTEM SET
'. S
SETTINGS
ELECT THE RELEVANT
-
.
UP

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents