System Configuration - TANDBERG Videoconferencing System Short User Manual

System configuration

• Switch the system on. Product logo and a power up menu will be displayed.
• Enabled but unused ISDN lines (lines not active) should be disabled:
menu
P M
RESS ENU ON THE REMOTE CONTROL
'L S '
RELEVANT INE ETUP
• Enter System Name to identify the system during an MCU conference. Select 'Utilities', 'System Name'and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in 'Terminal Settings', 'Language'.
• If you are using two monitors, set 'Utilities', 'Dual monitor: On'.
• To activate MultiSite and/or Presenter, insert an option key (see paperwork accompanying your system), see
'Terminal Settings', 'Software Options'.
• Press C
connect
ONNECT
• Using the monitor remote control, adjust the volume on the monitor to a level of your choice. This
volume will be the default volume for all calls.
ISDN configuration
For each installation of the system it is necessary to configure the unit. All configuration parameters are available
via the menu system.
• Press M on the remote control. Select the menu 'Terminal Settings', then 'Network'.
ENU
Set 'Current Network' to the network you want to use.
Specify the settings for the selected network in one of the menus.
Please refer to the User Manual for configuration of ISDN-PRI, Leased E1/T1 and External networks.
TANDBERG Videoconferencing System
. S
ELECT THE MENU
'E : O '.
MENU AND SET NABLED FF
on the remote control. A dial tone should be heard if the network is active.
'T S ', 'N ', 'ISDN-BRI
ERMINAL ETTINGS ETWORK
15
Installation
'. S
SETTINGS ELECT THE