System Configuration; System Set - Up - TANDBERG 1000 User Manual

Installation

System configuration

• Switch the system on by activating the power switch on the codec (located on the right hand side at the rear of
the unit).
• After the system has performed a self-test routine, product logo and a 'Welcome' menu will be displayed on the
monitor.
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key 'System Info' (on
the remote control) to view line status.
menu
P M
RESS ENU ON THE REMOTE CONTROL
'E
MENU AND SET NABLED
• Enter System Name to identify the system during an MCU conference. Select 'Utilities', 'System Name' and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in 'Terminal Settings', 'Language'.
• To activate a software option, enter an option key (see paperwork accompanying your system), see
'Terminal Settings', 'Software Options'.
• Press C
connect
ONNECT
TANDBERG Videoconferencing System
. S
ELECT THE MENU
: O '.
FF
on the remote control. A dial tone should be heard if the network is active.
'T S ', 'ISDN S
ERMINAL ETTINGS
12
NOTE T
HESE SETTINGS ARE
ESSENTIAL FOR OPTIMAL
SYSTEM SET
'. S
ETTINGS ELECT THE RELEVANT
- .
UP
'L S '
INE ETUP