System Configuration - TANDBERG 800 User Manual

System configuration

• Switch the system on by activating the power switch on the system.
• After the system has performed a self-test routine, product logo and a 'Welcome' menu will be displayed on the
monitor.
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key 'System Info' (on
the remote control) to view line status.
menu
P M
RESS ENU ON THE REMOTE CONTROL
'L S '
INE ETUP MENU AND SET
• Enter System Name to identify the system during an MCU conference. Select 'Utilities', 'System Name' and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in 'Terminal Settings', 'Language'.
• If you are using two monitors, set 'Utilities', 'Dual Monitor: On'.
• To activate MultiSite and/or Presenter, enter an option key (see paperwork accompanying your system), see
'Terminal Settings', 'Software Options'.
connect
• Press C
ONNECT
• Using the monitor remote control, adjust the volume on the monitor to a level of your choice. This
volume will be the default volume for all calls.
TANDBERG Videoconferencing System
. S
ELECT THE MENU
'E : O '.
NABLED FF
on the remote control. A dial tone should be heard if the network is active.
'T S ', 'N
ERMINAL ETTINGS ETWORK
15
T
NOTE
HESE SETTINGS ARE ESSENTIAL
FOR OPTIMAL SYSTEM SET
', 'ISDN-BRI '. S
SETTINGS ELECT THE RELEVANT
Installation
- .
UP