Table of Contents
Advertisement
General use
PC Presenter
Plugging a PC into the system is made extremely simple through the PC Presenter, avoiding the need for any
additional hardware such as a projector, PC/Video converter or extra cables.
• Connect a VGA-VGA cable from your PC (VGA Output) to the PC Presenter connector in front of the system
(behind the glass door).
• Start your PC.
• Press PC on your remote control.
• Press S
until the indicator 'Selfview' is displayed on your main monitor (single monitor system) or until
ELFVIEW
you see the PC image on the second monitor.
If no PC image is displayed on your monitor, make sure that your PC transmits the image to the VGA Output, and
that the PC transmits a supported VGA-format (see tip below). Consult your PC-operating manual to see how to
transmit a VGA image from your PC (typically: Fn+F5).
PC SoftPresenter *
PC SoftPresenter is used to display PC images on your system without using a VGA cable (PC Presenter). The
TANDBERG video conferencing system and your PC must be connected to a LAN. In addition, VNC (Virtual
Network Computing) server software must be installed on the PC.
To show the PC image:
• Start the VNC software on your PC.
• Press PC on your remote control. Use UP/DOWN to activate PAGE UP/PAGE DOWN on the PC.
For setup information and details, see 'VNC Settings' in 'Advanced use'.
* - Optional feature.
TANDBERG Videoconferencing System
44
VGA-
FORMATS SUPPORTED
·VGA
640X480
·SVGA 800X600
·XGA
1024X768 60,70,75 H
PC Presenter input
VGA Output
'PC: VNC'
NOTE
MUST BE SET IN
(VESA
)
COMPLIANT
60,72,75,85 H
Z
56,60,72,75,85 H
Z
Z
'V
S
'.
IDEO
ETTINGS
Hide quick links:
Advertisement
Table of Contents
