Replacing The Microsd Card; Preliminary Steps - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

14.6.4 Replacing the microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers

14.6.4.1 Preliminary steps

"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 51
Ê
14.6.4.2 Replacing the microSD card
Ê Remove the Dual microSD 64GB Enterprise, see section
Dual microSD 64GB Enterprise" on page
Ê Remove the defective microSD card from the Dual microSD 64GB
Enterprise. Proceed as described in the following:
Ê To eject the defective microSD card, gently push it in and then let go (see
figure 184).
Ê Pull the microSD card straight out of its slot.
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
Ê With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see figure 185).
TX1320 M4
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
"Removing the
299.
303