Replacing The Microsd Card - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

System board and components
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê

16.6.4.2 Replacing the microSD card

Ê Remove the Dual microSD 64GB Enterprise, see section
Dual microSD 64GB Enterprise" on page
Ê Remove the defective microSD card from the Dual microSD 64GB
Enterprise. Proceed as described in the following:
Ê To eject the defective microSD card, gently push it in and then let go (see
figure 401 on page
Ê Pull the microSD card straight out of its slot.
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
Ê With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see figure
Ê Install the Dual microSD 64GB Enterprise, see section
microSD 64GB Enterprise" on page
16.6.4.3 Concluding steps
Ê If applicable "Installing the air duct" on page 89
"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
534
532).
Upgrade and Maintenance Manual
529.
402 on page
524.
"Removing the
533).
"Installing the Dual
RX2540 M4