Expansion cards and backup units
9.4.2.3
Removing an expansion card
Ê If applicable, remove SFP+ transceiver modules from the expansion card,
see section
"Removing an SFP+ transceiver module" on page
Ê If an EP5x0i is installed, disconnect the HDD LED cable from the system
board.
Ê If applicable, disconnect internal cables from the expansion card.
Figure 96: Removing an expansion card
Ê Fold up the locking handle on the slot bracket clamp.
Ê Carefully remove the expansion card from its slot.
9.4.2.4
Installing the slot cover
V
CAUTION!
Always replace slot covers into unused PCI slot openings to comply with
applicable EMC regulations and satisfy cooling requirements.
188
Upgrade and Maintenance Manual
178.
TX1320 M4