Table of Contents
Advertisement
3.
Slide the Rip Fence (10C) back and forth. The Rip Fence should move freely
with about 1/16" clearance between the Rip Fence and Saw Table (17H) surface.
If it doesn't, loosen the Hex Nuts (13H) holding the Front Rail (7H) and adjust the
Front Rail up or down. (See Figure K.)
4.
Remove the Rip Fence (10C) and repeat on the other side of the Saw Blade
(14-I). When the Rip Fence moves smoothly, tighten all the Hex Nuts (13H) with
the Wrench (14-I). (See Figure K.)
5.
When finished, attach the Right and Left End Caps (8H, 9H) to the Front Rail
(7H), using the two Tapping Screws (1H). (See Figure K.)
RIP FENCE
(10C)
FIGURE K
To Attach The Blade Guard:
1.
This procedure will require use of the following hardware:
A. 2 Hex Bolts (2-I).
B. 3 Socket Head Screws (5D).
C. 2 Lock Washers (1-I).
D. 3 Washers (4D).
SKU 93491
For technical questions, please call 1-800-444-3353.
HOOK OVER
REAR RAIL
HERE
RIP FENCE
REAR RAIL
HANDLE
(3H)
(37C)
FRONT RAIL
(7H)
RIP FENCE
(10C)
RIGHT, LEFT
END CAPS
(8H, 9H)
TAPPING
SCREW
(1H)
Page 21
Advertisement
Table of Contents
