Central Machinery 93491 Assembly And Operating Instructions Manual page 47

TABLE BRACKETS (7-I)
BEVEL HAND WHEEL ROD THREADS (22-I)
9. To replace the V-Belt: This Table Saw uses a V-Belt (40-I) with a 44"
circumference by 1/2" wide. To replace the V-Belt, loosen the two Set Screws
(42-I). Push the Motor (7F) forward to release tension on the V-Belt. Open the
Outer Belt Guard
Motor Pulley and off the Spindle Pulley (42-I). Install a new V-Belt on the Motor
Pulley and Spindle Pulley. Pull back on the Motor to increase tension on the new
V-Belt. With moderate pressure, push the center of each V-Belt. Note the amount
of deflection. Deflection should be approximately 1/2". Then retighten the two Set
Screws (42-I), and close the Outer Belt Guard (1F).
(See Figure MM, next page.)
10. CAUTION! All maintenance, service, or repairs not mentioned in this
manual must only be performed by a qualified service technician.
SKU 93491 For technical questions, please call 1-800-444-3353.
(1F) to expose the Motor Pulley (5F). Slip the V-Belt off the
(FRONT OF TABLE SAW)
HEIGHT HAND WHEEL
ADJUSTMENT ROD (33-I)
AND TRUNNION (36-I)
FIGURE LL
Page 47