phASe 8: Saw Blade installation
Wear heavy duty work gloves
and ANSi-approved safety
goggles during assembly,
especially when handling blade.
FigUre FOr Step 8-1
15B
1.
Remove the four Knobs (15B) from the
Upper and Lower Pulley Guards (14B,
21B). Remove and set aside the Pulley
Guards.
FigUre FOr Step 8-2
2.
Remove the Table Insert (37B) and Table
Pin (38B).
SKU 32206/32208
tO preVeNt iNjUrY
FrOm ShArp BlADe:
tABle iNSert (37B)
tABle piN (38B)
For technical questions, please call 1-800-444-3353.
FigUre FOr Step 8-3
3.
Turn the Blade Tension Knob (5B) coun-
terclockwise about 5-10 full turns.
FigUre FOr Step 8-4
iNSert SAW
BlADe here,
BACK FirSt
4.
With both hands, hold the Saw Blade
with its teeth pointing downward and
away from your body. Then, insert the
Saw Blade (20B) back side first through
the slot in the Table (36B).
5B
teeth pOiNt
DOWNWArD
AS BelOW
reV 02d
PAGE 19