Central Machinery 93491 Assembly And Operating Instructions Manual page 22

2. Align the lower end of the Blade Guard Bracket (7D) and the threaded holes of
the Trunnion (36-I), and insert the two Hex Bolts (2-I) and Lock Washers (1-I).
Firmly tighten with the Wrench (17-I). (See Figure L.)
3. Temporarily remove the Throat Plate (15H). To do so, remove the four Set
Screws (14H). Then, lift the Throat Plate off the Saw Table (17H).
(See Figure L.)
TRUNNION
(36-I)
BLADE GUARD
BRACKET
(7D)
HEX BOLT
(2-I)
4. Place the Blade Guard Assembly (1D thru 13D) on the Saw Table (17H), aligning
the screw holes in the Riving Knife (6D) to the holes in the Blade Guard Bracket
(7D). Align the hole in the front of the Riving Knife Base (6D) with the screw hole
SOCKET HEAD SCREW (5D)
BLADE GUARD BRACKET
(7D)
SKU 93491 For technical questions, please call 1-800-444-3353.
LOCK
WASHER
(1-I)
WASHER (4D)
RIVING KNIFE
(6D)
THROAT PLATE
(15H)
FLAT HEAD
SCREW
(16H)
BLADE GUARD
(10D)
SET SCREW
(14H)
FIGURE L
FIGURE M
Page 22