Table of Contents
Advertisement
turning the Bevel Hand Wheel (4G) until the Bevel Scale (10G) on the cabinet
front reads zero. Then, retighten the Bevel Lock Handle (19-I). Make sure that
saw blade is at correct height for the workpiece to be cut. (See Figure FF.)
5.
If necessary, loosen the Miter Gauge Knob (2A) and set the Miter Gauge to 0
degrees. Then, retighten the Miter Gauge Knob. (See Figure FF.)
6.
Make sure the workpiece is not touching the Saw Blade (14-I).
7.
Plug the Power Cord Plug into the nearest 220 volt, grounded, electrical outlet.
Then, insert the Switch Key and pull the Power Switch (8E) to its "ON" position.
(See Figure BB.)
8.
Allow the Saw Blade (14-I) to spin up to full speed before feeding the workpiece
into the Saw Blade. (See Figure FF.)
9.
Hold the workpiece firmly against the Miter Gauge, and push the workpiece into
the Saw Blade (14-I). (See Figure FF.)
Make sure to gradually feed the workpiece into the Saw Blade (14-I). Do not
10.
attempt to force the Table Saw to cut faster or greater than its capacity.
(See Figure FF.)
11.
When the cut is completed, press the Power Switch (8E) to its "OFF" position and
remove the Switch Key. Then, unplug the Power Cord Plug from its electrical
outlet. (See Figure BB.)
SAW BLADE
(14-I)
ANGLED
BEVEL LOCK HANDLE
(NOT SHOWN)
SKU 93491
For technical questions, please call 1-800-444-3353.
BEVEL CROSS CUT
MITER GAUGE STRAIGHT
BEVEL HAND WHEEL (4G)
FIGURE FF
BEVEL LOCK
(VIEWED FROM THE FRONT, BELOW THE SAW TABLE)
HANDLE
(19-I)
Page 41
Advertisement
Table of Contents
