Table of Contents
Advertisement
when the cut has been completed.
(See Figure Y, next page.)
SWITCH
CUT-OFF
SCrEW
(77)
pOWEr SWITCH
14. Once the cut is made, turn the Power
Switch (20) to its "OFF" position.
Then unplug the Power Supply Cord
(97) from its electrical outlet.
15.
Wait until the Bandsaw has come to a
complete stop. Then raise the Body
Frame (126) to its full vertical position
and lock the Frame in place with the
Support Plate (31).
16.
Remove the workpiece from the Vise
(34, 36) assembly and scrap material
from the Bed (55) of the Bandsaw.
Then unlock the Support Plate (31)
and slowly lower the Body Frame
(126) to its horizontal position.
SKU 66435
FIGUrE Y
(20)
For technical questions, please call 1-800-444-3353.
MAINTENANCE AND
SErVICING
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FrOM ACCIDENTAL
OpErATION:
Turn the power Switch (20) of
the Bandsaw to its "OFF"
position and unplug the
machine from its electrical
outlet before performing any
inspection, maintenance, or
cleaning procedures.
TO prEVENT SErIOUS INjUrY
FrOM TOOL FAILUrE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Cleaning, Maintenance, and
Lubrication
1.
BEFORE EACH USE, inspect the gen-
eral condition of the Bandsaw. Check
for loose screws, misalignment or bind-
ing of moving parts, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect its
safe operation.
2.
SAW BLADE MAINTENANCE: Inspect
the Saw Blade (86). Using a dull Saw
Blade will cause excessive wear on
the Motor of the Bandsaw and will not
produce a satisfactory cut. Replace
with a new Saw Blade when needed.
To replace a Saw Blade:
TO prEVENT
SErIOUS INjUrY
Page 20
Advertisement
Table of Contents
