Table of Contents
Advertisement
Groove. (See Figure U.)
15.
If the Saw Blade (14-I) still is not parallel, adjust the Front Table Bracket (7-I).
(See Figure U.)
16.
Tilt the Saw Blade (14-I) to 45 degrees, using the Bevel Lock Handle (19-I) and
Bevel Hand Wheel (4G). (See Figure U.)
17.
From the back of the Table Saw, loosen the three Hex Head Bolts (9-I) holding
the Front Table Bracket (7-I) and loosen the three Hex Head Bolts (9-I) holding
the Rear Table Bracket (7-I) . (See Figure U.)
18.
Reposition the Saw Blade (14-I) to 90 degrees with the Bevel Lock Handle (19-I)
and Bevel Hand Wheel (4G). (See Figure U.)
19.
Lower the Saw Blade (14-I) and move the Front and Rear Table Brackets (7-I) as
needed. Then, retighten all six Hex Head Bolts (9-I). (See Figure U.)
20.
Raise the Saw Blade (14-I) and recheck. Repeat until the Saw Blade (14-I) is
parallel to the Miter Gauge Groove. (See Figure U.)
21.
When finished, reinstall the Throat Plate (15H) on the Saw Table (17H), making
sure the Throat Plate is flush with the Saw Table. (See Figure U.)
NOTE: BLADE GUARD (10D)
IS NOT SHOWN FOR CLARITY
FRAMING SQUARE
MARKED TOOTH
AT FRONT
FIGURE U
SKU 93491
For technical questions, please call 1-800-444-3353.
(NOT INCLUDED)
MITER GAUGE
GROOVE
MARKED TOOTH AT BACK
REAR TABLE BRACKET (7-I)
REAR
HEX
HEAD
BOLT (9-I)
FRONT
TABLE BRACKET (7-I)
FRONT HEX HEAD BOLT (9-I)
(VIEWED FROM BELOW)
FRAMING
SQUARE
(NOT INCLUDED)
REAR HEX HEAD BOLT (9-I)
Page 30
Advertisement
Table of Contents
