Central Machinery 93491 Assembly And Operating Instructions Manual page 16

2. This procedure will require use of the following hardware:
A. 4 Hex Bolts (8B).
B. 8 Hex Nuts (2B).
C. 8 Washers (3B).
3. Check to make sure the Saw Blade (14-I) is fully retracted inside the Saw Table
(17H). Then, carefully set the Saw Table upside down on the floor surface,
(protect the Table top from being damaged).
4. Place the Stand upside down on the Saw Table Base (1G). Align the holes in the
Base with the holes in the End Braces (6B). (See Figure G.)
5. Place a Washer (3B) on a Hex Head Bolt (8B) and insert the Hex Head Bolt
upward through one of the previously aligned holes. Cap the Hex Head Bolt with
a Washer (3B) and Hex Nut (2B). Hand tighten only. (See Figure G.)
6. Repeat Step #5 for the three remaining holes. Then tighten all hardware with the
Wrench (17-I). NOTE: Leave the Table Saw sitting upside down.
(See Figure G.)
HEX NUT (2B)
WASHER (3B)
WASHER (3B)
HEX BOLT (8B)
FIGURE G
SKU 93491 For technical questions, please call 1-800-444-3353.
(See Figure G.)
STAND LEG (4B)
BASE (1G)
Page 16