Table of Contents
Advertisement
Saw Table (17H). When using the left Groove, hold the workpiece firmly against
the Miter Gauge Base (4A) with your left hand and grip the Knob (2A) with your
right hand. When using the right Groove, hold the workpiece firmly against the
Miter Gauge Base with your right hand and grip the Knob with your left hand.
(See Figure CC.)
6.
Make sure the workpiece is not touching the Saw Blade (14-I).
7.
Plug the Power Cord Plug into the nearest 220 volt, grounded, electrical outlet.
Then, insert the Switch Key and pull the Power Switch (8E) to its "ON" position.
(See Figure BB.)
8.
Allow the Saw Blade (14-I) to spin up to full speed before feeding the workpiece
into the Saw Blade with the Miter Gauge. (See Figure CC.)
9.
Make sure to gradually feed the workpiece into the Saw Blade (14-I). Do not
attempt to force the Table Saw to cut faster or greater than its capacity.
(See Figure CC.)
10.
When the cut is completed, press the Power Switch (8E) to its "OFF" position and
remove the Switch Key. Then, unplug the Power Cord Plug from its electrical
outlet. (See Figure BB.)
SKU 93491
For technical questions, please call 1-800-444-3353.
PLACE LEFT HAND ON
WORKPIECE AND MITER
GAUGE BASE (4A) HERE.
CROSS CUT
MITER GAUGE KNOB (2A) HERE.
WHEN MITER GAUGE IS ON
LEFT SIDE OF SAW BLADE
PLACE RIGHT HAND ON
FIGURE CC
Page 37
Advertisement
Table of Contents
