Rcl (Recall) - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

*RCL (Recall)

Command Syntax
*RCL <value>
<value> ::= {0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9}
The *RCL command restores the state of the instrument from the specified
save/recall register.
See Also
•
•
110
(see page 658)
"Introduction to Common (*) Commands"
"*SAV (Save)" on page 114
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 99