External:probe:stype - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:EXTernal:PROBe:STYPe

Command Syntax
This command is valid only for the 113xA Series probes.
N O T E
:EXTernal:PROBe:STYPe <signal type>
<signal type> ::= {DIFFerential | SINGle}
The :EXTernal:PROBe:STYPe command sets the external trigger probe
signal type (STYPe) to differential or single- ended when using the 113xA
Series probes and determines how offset is applied.
Query Syntax
:EXTernal:PROBe:STYPe?
The :EXTernal:PROBe:STYPe? query returns the current probe signal type
setting for the external trigger.
Return Format
<signal type><NL>
<signal type> ::= {DIFF | SING}
See Also
•
224
(see page 658)
"Introduction to :EXTernal Trigger Commands"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 218