Opc (Operation Complete) - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

*OPC (Operation Complete)

Command Syntax
*OPC
The *OPC command sets the operation complete bit in the Standard Event
Status Register when all pending device operations have finished.
Query Syntax
*OPC?
The *OPC? query places an ASCII "1" in the output queue when all
pending device operations have completed. The interface hangs until this
query returns.
Return Format
<complete><NL>
<complete> ::= 1
See Also •
•
•
•
108
(see page 658)
"Introduction to Common (*) Commands"
"*ESE (Standard Event Status Enable)"
"*ESR (Standard Event Status Register)"
"*CLS (Clear Status)"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 102
on page 104
on page 101
on page 99