Track Replacement; Remove Track; Install Track - Ariens Professional Sno-Thro Series Service Manual

TRACK REPLACEMENT

Remove Track

IMPORTANT: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 7.
4. Remove track drive wheel. See Remove Track Drive
Wheel on page 60.
5. Remove track from carriage assembly. See
Figure 148 and Figure 149.
Model 926337
Figure 148
Models 926060, 926069, 926338
Figure 149

Install Track

See Figure 150 and Figure 151.
IMPORTANT: Tracks are directional and MUST be installed
in the orientation shown in Figure 150 and Figure 151.
1. Install track onto carriage assembly and align with
bogie wheel(s) and track runner, if applicable.
2. Reinstall track drive wheel. See Install Track Drive
Wheel on page 60.
Model 926337
1
1. Track Drive Wheel
2. Bogie Wheel
3. Track Runner
1
1. Track Drive Wheel
2. Bogie Wheel
3. Return unit to operating position.
EN – 62
Figure 150
Models 926060, 926069, 926338
2
Figure 151
2
3