Ariens Professional Sno-Thro Series Service Manual page 29

See Figure 55.
14. Reinstall stepped spacer onto hex bolt and insert bolt
through frame front from inside frame.
IMPORTANT: Make sure bushing is in correct orientation
so stepped-down end of bushing inserts through frame.
15. Reinstall pocket bushing onto hex bolt so flat face of
bushing is forward.
16. Reinstall idler pulley onto hex bolt and secure with one
flat steel washer and locking nut.
17. Reinstall traction drive belt. See Install Traction Drive
Belt on page 17.
Figure 54
5
1. Stepped Spacer
2. Pocket Bushing
3. Idler Pulley
4. Flat Steel Washer
5. Locking Nut
18. Reinstall housing to frame. See Reinstall Auger
Housing on page 11.
19. Reinstall bottom cover. See Install Bottom Cover on
page 15.
20. Return unit to operating position.
21. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
EN – 28
3
4
Figure 55
1
2