Remove Right Bearing - Ariens Professional Sno-Thro Series Service Manual

8. Reinstall track drive wheel and reinstall track. See
Install Track Drive Wheel on page 60 and Install Track
on page 61.
9. Return unit to operating position.
10. Model 926337: Adjust track tension. Refer to
Operator's Manual for adjustment procedure.
11. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.

Remove Right Bearing

IMPORTANT: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 7.
4. Remove track drive wheel and remove track. See
Remove Track Drive Wheel on page 60 and Remove
Track on page 61.
5. Remove bottom cover. See Remove Bottom Cover on
page 14.
See Figure 160 and Figure 161.
6. Remove E-ring from right axle end.
7. Models 926060, 926069, 926338: Remove hubs from
axle ends.
Model 926337: Remove flat steel washers from axle
ends.
8. Remove long axle from differential gear.
EN – 66
Models 926060, 926069, 926338
Figure 160