Ariens Professional Sno-Thro Series Service Manual page 70

See Figure 168 and Figure 169.
6. Reinstall long axle into differential gear.
7. Models 926060, 926069, 926338: Reinstall hub onto
each axle end.
Model 926337: Reinstall one flat steel washer onto
each axle end.
Model 926337
8. Reinstall E-ring onto right axle end.
9. Tighten hardware securing mount plates to track
carriage.
10. Reinstall bottom cover and secure with four hex bolts
and two tapping screws. Tighten hardware.
11. Reinstall track drive wheel and reinstall track. See
Install Track Drive Wheel on page 60 and Install Track
on page 61.
12. Return unit to operating position.
13. Model 926337: Adjust track tension. Refer to
Operator's Manual for adjustment procedure.
14. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
Models 926060, 926069, 926338
Figure 168
Figure 169
EN – 69