Tm31 Terminal Module - Siemens SINAMICS G130 Operating Instructions Manual

Note
Installing the Control Unit
With frame sizes FX and GX, the Control Unit is installed to the left of the Power Module.
The required connection elements are supplied with the Power Module.
With frame sizes HX and JX, the Control Unit is installed in the Power Module.
Control Unit: Memory card
The memory card contains the control software and parameters.
Note
Possible plant standstill by withdrawing or inserting the memory card in operation
If the memory card is withdrawn or inserted during operation, then data can be lost, possibly
resulting in a plant standstill.
• Only withdraw and insert the memory card when the Control Unit is in a no-voltage
condition.
3.6

TM31 Terminal Module

Description
The TM31 Terminal Module is a terminal extension board. The TM31 can be used to
increase the number of digital inputs/outputs. Analog inputs and outputs are also available
on the TM31.
Fire hazard due to overheating because of inadequate ventilation clearances
Insufficient ventilation clearances result in overheating with danger to persons as a result of
smoke and fire. This can also result in more downtimes and reduced service lives of the
Terminal Module.
• For this reason, it is imperative that you maintain the 50 mm clearances above and
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
WARNING
below the Terminal Module.
Mechanical installation
3.6 TM31 Terminal Module
43