Siemens SINAMICS G130 Operating Instructions Manual page 134

Commissioning
5.3 Procedure for commissioning via STARTER
Figure 5-7
Note
Activate PG/PC is the only master on the bus
You must activate PG/PC is the only master on bus if no other master (PC, S7, etc.) is
available on the bus.
Note
Configure even without an interface
Projects can be created and PROFIBUS addresses for the drive objects assigned even if a
PROFIBUS interface has not been installed on the PC.
To prevent bus addresses from being assigned more than once, only the bus addresses
available in the project are proposed.
When required, a manual address entry can also be used to enter an already assigned
address.
⇒ After completion, click OK to confirm the settings and to return to the project wizard.
134
Setting the interface - properties
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A