Siemens SINAMICS G130 Operating Instructions Manual page 205

CU320 terminal assignment with "PROFIdrive" default setting
When you choose the "PROFIdrive" default setting, use the following terminal assignment for
the Control Unit:
Figure 6-10
Control word 1
The bit assignment for control word 1 is described in "Description of the control words and
setpoints".
Status word 1
The bit assignment for status word 1 is described in "Description of the status words and
actual values".
Changing over the command source
The command source can be changed over using the LOCAL/REMOTE key on the AOP30.
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
Terminal assignment, Control Unit with the "PROFIdrive" default setting
Operation
6.4 Command sources
205