Web Server - Siemens SINAMICS G130 Operating Instructions Manual

9.2.23

Web server

9.2.23.1 Description
General information
The integrated web server provides information about the drive unit via its web pages. This is
accessed via an Internet browser. The information on the Web pages is shown in English.
For information about message texts, drive object states and parameter names, there is a
language selection which allows a switchover of the display to the languages that are stored
on the memory card.
The most important functions of the Web server are described below. However, the "Files"
and "User´s Area" display areas of the Web server are described in detail in a separate
document (see "User-defined Web pages"). For this reason, these display areas are not
described in this description.
Activation/configuration
The web server is already active in the factory settings.
The web server is configured via parameter p8986 (web server configuration).
Data transfer
Access is performed by unsecured (http) or secured transmission (https).
The type of transmission is defined by entering the corresponding address.
For safety reasons, secure transmission can be forced by deactivation of the http port.
Access
The web server is accessed via the following interfaces:
● LAN interface of the Control Unit CU320-2 DP or CU320-2 PN
● PROFINET interface of the CU320-2 PN
Addressing of the drive is based on the IP address.
The IP address can be taken from the following parameters.
● Integrated Ethernet interface (LAN interface): r8911[0...3]
● PROFINET interface: r8931[0...3]
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
Functions, monitoring, and protective functions
9.2 Drive functions
443