Command Sources - Siemens SINAMICS G130 Operating Instructions Manual

Operation

6.4 Command sources

6.4 Command sources
6.4.1 "PROFIdrive" default setting
Preconditions
● The Power Module and the Control Unit have been correctly installed.
● The "PROFIdrive" default setting was chosen during commissioning:
• STARTER (p0700):
• AOP30 (p0700):
Command sources
Figure 6-9
Priority
The command source priorities are shown in the diagram "Command sources - AOP30 <->
PROFIdrive".
Note
LOCAL master control
All of the supplementary setpoints are deactivated for LOCAL master control.
204
"PROFIdrive"
"1: G130 PROFIdrive"
Command sources – AOP30 <--> PROFIdrive
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A