Step 0.3 - Set Up Machine Data For Measuring In Jog - Siemens SINUMERIK 840D sl Programming Manual

Start-up (hardware)
10.2 Steps for commissioning measuring cycles for the first time
10.2.4

Step 0.3 - set up machine data for measuring in JOG

• The following machine data should only be parameterized for the "Measuring in JOG"
• The following machine data must be observed:
Then perform an NC reset. (HMI\Commissioning\NC reset)
HMI variants
The next steps of commissioning depend on the HMI hardware and software used.
HMI version (HMI\Diagnosis\Service displays\Version\HMI)
1.
2.
3.
4.
10-4
function
(for details, see section 9.3 "Data for measuring in JOG")
MD11602: ASUP_START_MASK
MD11604: ASUP_START_PRIO_LEVEL
MD20110: RESET_MODE_MASK
MD20112: START_MODE_MASK
MD20050: AXCONF_GEOAX_ASSIGN[i]
HMI-Advanced PCU50 powerline
up to SW 06.03.18 or up to SW 06.04.08
as of SW 06.03.19 or as of SW 06.04.10
HMI-Advanced PCU50 solution line
HMI-Embedded PCU20 powerline
HMI-Embedded TCU solution line SW 1.x
→ continue with section 10.3
→ continue with section 10.4
→ continue with section 10.4
→ continue with section 10.5
→ continue with section 10.6
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles