Siemens SINUMERIK 840D sl Programming Manual page 529

Channel-specific values (for measuring in JOG, from measuring cycles SW6.3, GUD7_MC)
Block Identifier
GUD7 E_MESS_AM
1) During installation value input is mandatory here!
Channel-oriented bits
Block Identifier
_CHBIT
GUD6 _CHBIT[0]
GUD6 _CHBIT[1]
GUD6 _CHBIT[2]
GUD6 _CHBIT[3]
GUD6 _CHBIT[4]
GUD6 _CHBIT[5]
GUD6 _CHBIT[6]
GUD6 _CHBIT[7]
GUD6 _CHBIT[8]
GUD6 _CHBIT[9]
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Description
Internal data item
Description
Channel bits
Measurement input for workpiece measurement
0: measurement input 1
1: measurement input 2
Measurement input for tool measurement:
0: measurement input 1
1: measurement input 2
Collision monitoring for intermediate positioning
0: OFF
1: ON
Tool offset mode with tool measurement
0: first-time measurement (determining geometry)
1: remeasuring (determining wear)
Mean value for workpiece measurement with automatic tool correction
(_EVNUM>0)
0: no mean value derivation over several parts
1: with mean value formation and calculation
Inclusion of empirical value (_EVNUM>0)
0: subtraction of actual value
1: addition to actual value
Tool offset mode for workpiece measurement with automatic tool offset
0: Offset in wear
1: offset in geometry, delete wear
From meas. cycles SW 6.3:
For additive and setup offset and _CHBIT[8]=0:
0: offset in additive offset
1: offset in set-up offset, delete additive offset
Measured value offset in CYCLE994
0: use of trigger values of the probe _WP[k,1] ...
1: use of the active ball diameter of the probe _WP[k,0]
From meas. cycles SW 6.3:
Offset mode for workpiece measurement with automatic tool offset
0: additive, setup offset according to _CHBIT[6]
1: offset additive in set-up offset, irrespective of _CHBIT[6]
currently not assigned
A.1 Overview of measuring cycle parameters
Appendix
As-delivered value
As-delivered
value
0
1
1
0
0
0
0
0
0
0
A-39