Loading Files For Measuring In Jog - Siemens SINUMERIK 840D sl Programming Manual

_JM_B[ ]
BOOL value field for JOG measurement
Changes valid after value assignment
Data type BOOLEAN
Significance:
_JM_B[0]
_JM_B[1]
_JM_B[2]
_JM_B[3]
_JM_B[4]
_JM_B[5]
_JM_B[6]
9.3.4

Loading files for measuring in JOG

File transfer from software supplied
The following files located in the JOG_MEAS\CYCLES\SPFFILES directory on the software
supplied are transferred to the control into directory "Standard cycles" from the diskette in
menu "Services" after selection of softkey "Data in", "Diskette" and selection of the file in
question and then pressing the "Start" softkey. They must then be loaded into the NC
memory by pressing the softkey "Load". After the next Power on, they are known to the
control.
File
CYC_JM.SPF
CYC_JMA.SPF
CYC_JMC.SPF
E_MS_CAL.SPF
E_MS_CAN.SPF
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Min. input limit: -
Protection level: -
Tool offset mode for tool measurement
0 offset in geometry on tool measurement
1 Offset in wear
Number of measurement attempts
0 5 measurement attempts
1 1 measurement attempt
Retraction from the measuring location
0 retraction as for intermediate positioning
1 retraction with rapid traverse
Fast measuring feed
0 measuring with measuring feed
1 1. measuring with feed in _SPEED[3]
2. measuring with measuring feed
0 Selection "basic frame" in the screen means offset in last
channel-specific basic frame
1 Selection of "basis" in screen form means offset in "Setting
zero point" system frame ($P_SETFRAME)
unassigned
Internal data item
Description
Auxiliary cycle for measuring
Aux. cycle for activation
Aux. cycle for calculation
For calibrating a workpiece measuring probe
To measure a corner
Data description
9.3 Data for measuring in JOG
Max. input limit: -
Units: -
Applies as of SW SW 5.3
Preset default
0
1
0
0
0
0
0
9-47