Siemens SINUMERIK 840D sl Programming Manual page 255

Traversing between P 1 and P 3 on outside edge:
• _ID=0:
• _ID>0:
Position after end of measuring cycle
The probe is again positioned at the starting point (at measuring depth opposite the
measured corner).
Selection of offset with _SETV[4]
With measuring variants MVAR=105, =106 (rectangle) the measured corner can be selected
offset as workpiece zero.
The offset is specified in _SETV[2] (abscissa) and _SETV[3] (ordinate).
_SETV[4] can assume values 1 to 4.
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
The corner is traveled around.
For P 1, after the measurement, is raised by _ID in the applicate and P 3 is approached
via corner.
Measuring Cycles for Milling and Machining Centers
5.8 CYCLE961 workpiece: Setup inside and outside corner
5-121