Memory Configuring Machine Data, Dram - Siemens SINUMERIK 840D sl Programming Manual

28083 MM_SYSTEM_DATAFRAME_MASK
MD number System frames (SRAM)
Default setting: 21Hex
1)
Default setting: 21Hex
2)
When using measuring cycles: 21 Hex
Bit 5 = 1
Changes effective after POWER ON
Data type:INTEGER
Significance: The following applies to measuring cycles:
Bit 0: 1 system frames for preset mode and scratching, recommended
Bit 5: 1 system frames for cycles (must always be available for measuring cycles)
1) up to NCK software version 59.xx.yy
2) as of NCK software version 63.xx.yy
3) If bit 0 = 0, then corrections cannot be made in the basic frame in "Measuring in JOG" and the parameterization variant
KNUM=2000 cannot be used when measuring in automatic mode!
9.1.1.3

Memory configuring machine data, DRAM

18170 MM_NUM_MAX_FUNC_NAMES
MD number Number of names of miscellaneous functions - cycles
Default setting: 40
1)
Default setting: 100
2)
When using measuring cycles: 80
Changes effective after POWER ON
Data type DWORD
Significance: Number of cycles with input parameters (DRAM)
1) up to NCK software version 59.xx.yy
2) as of NCK software version 63.xx.yy
18180 MM_NUM_MAX_FUNC_PARAM
Number of parameters in the additional functions - cycles
MD number
Default setting: 300
1)
Default setting: 1000
2)
When using measuring cycles: 800
Changes effective after POWER ON
Data type DWORD
Significance: Number of parameters for cycles acc. to MD 18170 (DRAM)
1) up to NCK software version 59.xx.yy
2) as of NCK software version 63.xx.yy
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Min. input limit: 0
Protection level: 2/7
Min. input limit: 0
Protection level: 2/7
Min. input limit: 0
Protection level: 2/7
9.1 Machine data for machine cycle runs
Max. input limit: 7Fhex
Units: -
Applies as of SW SW 6.3
3)
Max. input limit: plus
Units: -
Applies as of SW SW 1
Max. input limit: plus
Units: -
Applies as of SW SW 1
Data description
9-5