Onboarding Process - Creating New Motor Data Set - Siemens SIMOTICS CONNECT 400 Operating Instructions Manual

– If the motor is not found in the motor database by a combination of the serial number and
See also
Onboarding process - creating new motor data set (Page 41)
6.7.6

Onboarding process - creating new motor data set

If the motor is not found in the motor database by a combination of the serial number and the
product article number, you will have to enter the motor data yourself and save it in the
database. This applies both to Siemens motors and to motors of other manufacturers.
Note
Settings cannot be modified subsequently
Carefully select the following settings. There is no way of modifying the settings after
onboarding. A subsequent change can only be made by Siemens Service (Page 72).
SIMOTICS CONNECT 400
Operating Instructions, 05/2020, A5E50161952A AA
6.7 Onboarding process using the "SIDRIVE IQ Config" application
the product article number, the following message is displayed:
Confirm this dialog box with "Next" and, to create a new motor data set, follow the
instructions in Chapter Onboarding process - creating a new motor data set.
With the "Back" button, you can check the data that you entered, correct them if
necessary and restart onboarding.
Commissioning
41