Siemens SINUMERIK 840D sl Programming Manual page 455

MD Date
ShopMill
9764 E_MESS_MT_AX[3]=SET(133.133.13
3)
9765 E_MESS_MT_DL[3]
9766 E_MESS_MT_DR[3]
9767 E_MESS_MT_DZ[3]=SET(2,2,2)
9768 E_MESS_MT_DIR[3]=SET(-1,-1,-1)
9772 E_MESS_MT_D=10
9773 E_MESS_MT_FM=100
9774 E_MESS_MT_CF=0
9775 E_MESS_MT_COMP=0
E_MESS[3]
E_MEAS
E_MESS_RETT
9776 E_MESS_SETT[10]
E_MESS_AM
9778 E_MESS_MS_SOUTH01
9779 E_MESS_MS_MONO=0
Notice
Arrays E_MESS_MT_DL[] and E_MESS_DR[] (active diameter, width of tool measuring
probe for length/radius measurement) must be assigned.
E_MESS_SETT[ ]
Field for settings
Changes valid after value assignment
Data type BOOL
Significance
:
E_MESS_SETT[0
E_MESS_SETT[1...9]
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Data type
INTEGER
REAL
REAL
REAL
INTEGER
REAL
REAL
INTEGER
INTEGER
REAL
REAL
FRAME
BOOL
BOOL
INTEGER
INTEGER
Min. input limit: 0
Protection level: -
0: Spindle coupling with coordinate rotation
1: Spindle position on cycle call is initial position
Internal data item
Meaning
Permissible axis directions for tool probes in X and Y in
plus and minus direction, in Z in minus direction only
Active diameter of tool measuring probe for length
measurement
Active diameter of tool measuring probe for radius
measurement
Distance between upper edge of tool probe and
lower edge of tool probe [mm] when measuring the
tool radius
Approach direction in plane of tool measuring
probe for tool measurement (minus direction in 1st
plane axis)
Calibrate measurement path for tool probe and tool
measurement with motionless spindle (before and after
expected switching position)
Calibrate measuring feed for tool probe and tool
measurement with motionless spindle
No tool probe make (manufacturer) specified
No offset of the measurement result on tool measurement
with rotating spindle
Internal values
Internal values
Internal values
Field for settings
Internal values
Probe is used with reference to the probe sphere end
Probe is treated as multi probe
Max. input limit: 1
Units: -
Applies as of SW SW 6.2
Data description
9.3 Data for measuring in JOG
Preset default
0
0
0
2
-1
9-45